User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
DigiMux
Advanced Operations 65
Setting Up Remote Notification
The Remote Notification Set up menu allows you to set up the parameters needed to
fully enable remote notification using the methods specified in the Remote
Notification menu. The correct entries for these parameters allow the DigiMux to
locate the remote device(s) for notification.
In the Remote Notification menu, select Set up and press Enter. The following menu is
displayed:
DigiAlert (Dial) Enables (ON) or disables (OFF) DigiAlert notification of an
alarm event over a dial-up modem. When an alarm event is
triggered and DigiAlert (Dial) is ON, information
concerning the alarm event is dispatched to a specific IP
address. The PC at that IP address must have the DigiAlert
application installed in order to receive the alarm
notification. The default setting is ON.
NOTE: DigiAlert (Dial) requires an external USB Modem,
or an RS-232 Modem with a USB to RS-232
converter. A dedicated analog standard POTS line
is also required. Do not use a PBX or digital line
with this modem.
Preemptive Dial
Out
Enables (ON) or disables (OFF) preemptive dial out for
event notification. When an alarm event is triggered and
Preemptive Dial Out is ON, then any other modem-based
operations are interrupted in order for alarm notification to
occur over the modem. The default setting is ON.
Set up Allows you to set up remote notification using one or more
of the methods in the Remote Notification menu. For more
details, see
MENU ITEM DESCRIPTION
Set up
1 DigiAlert IP xxx.xxx.xxx.xxx
2 E-Mail Address
3 Pager Number
4 Dial-Out Phone No