User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
60 Advanced Operations
Day/Night Switch
The Day/Night Switch item determines the behavior of the DigiMux alarm processor
in response to an external NO (normally open) Day/Night switch. In the Alarm Set
Up Menu, move the cursor to Day/Night Switch and press Enter. The following menu
is displayed:
Items in the Day/Night Switch menu are described in the following table:
Day/Night Switch
1 Day/Night SW OFF
2 Switch <ON> Day
3 Delay For Active 1 min
MENU ITEM DESCRIPTION
Day/Night SW Determines whether the Day/Night switch settings are used.
Use Left/Right to select ON (enabled) or OFF (disabled).
When enabled, the position of the Day/Night Switch overrides
the alarm schedule time frames.
When disabled, the Day/Night Switch signal is ignored, and
the alarm processor follows the time frames as defined in
Night, Day, and Weekend Schedules on page 52. The default
setting is OFF (disabled).
Switch <ON> Configures whether the alarm setting follows Night or Day
settings when the Day/Night SW is set to ON (enabled) and the
Day/Night Switch (normally open) is activated.
Select Night or Day for the appropriate schedule when the
Day/Night Switch is activated. The default setting is Day.
Delay For Active Sets the time delay between the moment the switch setting is
changed and the moment the change takes effect, allowing
time for the person activating the switch to exit the area
without triggering a false alarm. For example, the Night setting
may enable the Motion Detection for the channel
corresponding to the camera monitoring the hallway through
which the person who activates the switch must exit, making a
delay necessary.
The setting can be 1, 2, 3, 4, or 5 minutes. The default setting is
1 minute.