User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
DigiMux
Advanced Operations 55
During normal recording, Camera 2 is recorded in sequence. The Unchanged Event
Record Mode indicates that there is no change in the recording mode for events. The
Normal Operation displayed in the figure above is used. The Interleaved mode
indicates that the alarmed video is recorded every other frame, while the other
cameras are recorded in their normal sequence. If Exclusive is selected as the Event
Record Mode, only the video from the alarmed camera is recorded until the alarm
expires.
Circular Recording
Circular Recording enables the DigiMux to continuously record video without
stopping. When the hard disk drive is full, the unit then begins to reclaim the storage
taken by the oldest previously recorded video, and stores new video over those
reclaimed spaces. When Circular Recording is set to OFF, recording stops when the
hard drive is full. This mode is called linear recording.
Figure 10 — Event Record Modes, Camera 2, Four-Camera Installation
1
4
3
2
1
4
3
2
Nor mal Operation
Seq uence of imag es r ecorded
1
2
1
2
4
2
3
2
Motion Detection Alarm on Channel 2,
Interleaved A larm V ideo
Seq uence of imag es r ecorded
ALARM ALARMALARMALARM
1
4
3
2
2
2
2
2
Motion Detection Alarm on Channel 2,
Exclusive Alarm Video
Seq uence of imag es r ecorded
ALARM ALARM