User`s manual

DigiMux
Basic Operations 31
Calling Presets
To call a preset in Dome Control, follow these steps for the affected camera:
1. To enter Dome Control, access Full Screen by pressing a Camera key, then
press
Set.
2. Press 1 to select the Go Preset function.
The Go Preset menu is displayed.
3. Select the desired preset number from the menu using the Direction keys
(Up/Down).
4. Press Enter.
The camera moves to display the preset position
Running Patterns
The Run Pattern menu enables you to run any pre-programmed patterns associated
with dome cameras. (Patterns are programmed separately using other equipment.)
To run a pattern, press Set for Dome Control, and Set again to select Run Pattern. The
Run Pattern menu is displayed, as shown below:
Select the pattern you want to run using the Camera keys or the Direction keys and
press Enter. The dome starts to run the selected pattern.
Run Pattern
1 Pattern 1 9 Pattern 9
2 Pattern 2 10 Pattern 10
3 Pattern 3 11 Pattern 11
4 Pattern 4 12 Pattern 12
5 Pattern 5 13 Pattern 13
6 Pattern 6 14 Pattern 14
7 Pattern 7 15 Pattern 15
8 Pattern 8 16 Pattern 16