User`s manual

User’s Manual
28 Basic Operations
DOME CONTROL
DigiMux allows you to control a dome camera using the front panel. While in Live
and Full Screen display mode (see Figure
3 on page 13), press the Camera key to
display the desired dome camera in full view. To enter Dome Control mode (Figure 7,
below), press the Set key. The dome operation parameters are then displayed in the
Dome Control Menu on the screen. If no key is pressed for 5 seconds, the menu
disappears.
NOTE: If you do not wish to view the Dome Control Menu while controlling the dome,
press 3 to hide the parameters.
The function keys used in Dome Control are shown in the following figure:
NOTE: The 9 channel and 4 channel DigiMux front panels have nine keys for
9
channels and four keys for 4 channels, respectively.
The DigiMux function keys on the front panel, as used in Dome Control mode, are
described in the table below.
Figure 7 — 16 Channel DigiMux Front Panel in Dome Control Mode
Pan/Tilt Iris Open
Focus Near
Zoom Out
Zoom In
Focus FarIris Close
Set Preset
Go Preset
Toggle Hint Screen
Set
ESC
Auto/Enter
FUNCTION
KEY
KEY ICON DESCRIPTION
Go Preset Use after you have set up presets with the Set Preset
function. Go Preset allows you to call the preset for
viewing. For information on how to call a preset, see
Calling Presets on page 31.