User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
24 Basic Operations
Event List Playback
You can play back video that is specific to an alarm event. Alarm events are listed in
an Event List that holds up to 2000 events.
The Event List can display only the first 256 pages of events. As some events are
deleted, others are displayed. Events in the alarm partition are displayed first on the
list, so if the Event List has more than 2000 events, all events displayed on the list are
from event partition.
The Event List
The Event List contains a history, or record, of events that have triggered alarms on
the DigiMux. If you have not set up an event partition, the events are stored in the
normal partition with all other video. These events are displayed in the Event List
only once. If an event partition is set up, then the events are stored in the normal
partition with all other video, and a copy of the event is made in the event partition
along with any specified pre-alarm video. The Event List displays events from the
event partition with an “E” next to them, and displays the event again because the
video for that event also resides in the normal partition.
NOTE: If one of the partitions (event or normal) is full and record is set to linear mode,
the pre-alarm video will not be copied into the event partition.
The figure on the next page shows the normal and event partitions, and how events
are stored and copied.