User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
16 Basic Operations
VIEWING LIVE AND PLAYBACK VIDEO IMAGES
Main Monitor View Formats
The Main monitor displays designated cameras or video playback in a versatile multi-
window view format. The available view formats are illustrated below.
Press any Camera key to view a camera channel in full view. To switch between
available view formats, press Mode.
PIP View Mode
The PIP (picture in picture) view mode allows you to view video from a small frame
in the lower right corner while video from another camera is displayed in full view.
When you first view PIP, camera 01 is displayed in full view and camera 02 is
displayed on the lower left. To assign cameras to the two viewing areas, follow these
steps:
1. Press the Set key.
2. Press a numbered Camera select key to assign a camera to the full view display
area.
3. Press another numbered Camera select key to assign a camera to the small, lower
right corner view area.
4. Press Set again to end the assignment.
Figure 4 — Available View Formats
1
9
16
full view
4
1
2 x 2
4 x 4
3 x 3
2
PIP