User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
8 System Installation
other units on the network. See IP Address Setup Information on page 122 for
information on how to set up your unit’s IP address.
• It is possible to have multiple units, dome cameras, and keyboard devices installed
on the same RS-485 bus. If this is the case, make sure that each device has its own
unique address.
• The ControlCenter 200/300 Keyboard requires an RJ-11 to RJ-45 adapter or
connector. If there are multiple keyboards, the first keyboard connected is
powered by the RJ-11 port, while the remaining connected keyboards must use a
separate power source.
WARNING: POWER SHOULD BE OFF BEFORE MAKING CONNECTIONS.
BASIC REAR PANEL CONNECTIONS
1. Make sure power is OFF (unit is unplugged).
2. Connect the video signal from each camera to one of the video input BNC
connectors marked Camera Input.
3. Connect the Main Monitor to the Main Monitor output of the unit (either BNC or
S-VHS connector).
4. Connect the power adapter to the DC jack at the lower right of the rear panel.
NOTE: Make sure the input voltage is DC19V, or at least 65 Watts, or the DigiMux will
not power up.
NOTE: The 4 channel and 9 channel DigiMux rear panels have 4 and 9 camera input
and camera looping out connectors, respectively.
Back panel connections are described below:
Figure 2 — 16 Channel DigiMux Rear Panel
Ethernet Main Monitor Power Jack
RS-485 Audio I/O Connector Call Monitor (BNC)
Camera Looping (1-16)
Input (1-16)
USB IEEE-1394 Main Monitor
BNC
(FireWire
®
)(RJ45) S-VHS
Ground
(RJ-11)
USB (2) USB ports for external USB devices, i.e., CD-RW or a hard disk
drive (HDD).