User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
144 Appendices
Symptom: The Power LED does not light up after plugging in the 19V DC connector.
Reason1: The power source is supplying power that is under or over the
correct voltage (19V+-3V, or greater than 65 Watts).
Solution: Replace the power supply and retry the connection.
Reason2: The 19V Adaptor is damaged.
Solution: Replace the 19V adapter and retry the connection.
Reason3: The 19V DC jack on the rear panel has a poor contact.
Solution: Improve the center contact (Positive polar) of the DC jack.
Reason4: The Front Panel Board is damaged.
Solution: Contact a qualified service person to replace the Front Panel Board.
Symptom: The Power LED is flashing after plugging in the 19V DC connector.
Reason: The 19V Adaptor is damaged.
Solution: Replace the 19V adapter and retry the connection.
Reason2: The 19V DC jack on the rear panel has a poor contact.
Solution: Improve the center contact (Positive polar) of the DC jack.
Symptom: The buzzer is beeping and a warning message indicates that the Fan is damaged.
Reason: The Fan is damaged.
Solution: Contact a qualified service person to replace the Fan.
Reason2: The Main Board is damaged.
Solution: Contact a qualified service person to replace the Main Board.
Symptom: The DigiMux does not work, even though the power is on.
The Front Panel LEDs remain in standby mode (all LEDs light up, one after another, in
a cycle) for more than 5 minutes after plugging in the 19V DC power source. The
Power LED lights up normally.
NOTE: When input voltage is not within DC19V +/- 3V, or is greater than 65 Watts, the
Digimux will shut down.
Reason: The Host Computer failed.
Solution: Contact a qualified service person to replace the Host Computer.