User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
DigiMux
Appendices 143
Reason3: The DigiMux settings are incorrect.
Solution: Load Factory Settings, and then check to determine whether or not
there are failure symptoms.
Reason4: The Main Board is damaged.
Solution: Contact a qualified service person to replace the Main Board.
Symptom: There is an RS-485 remote communication problem.
The keyboard cannot control the DigiMux through the RS-485 connection, or DigiMux
cannot control dome cameras.
Reason: The RS-485 port settings are incorrect.
Solution: Change the settings on the DigiMux and/or the devices connected to
the RS-485 bus such that they match. For example, the ControlCenter
200 or 300 keyboard must be set to 4800 baud to work with the
DigiMux. See
RS-485 Setup on page 81 and RS-485 Port Settings on
page 82 for more information.
Reason2: A cable between the unit and a device failed.
Solution: Replace the cable.
Reason3: The RS-485 / transceiver circuit failed.
Solution: Contact a qualified service person to replace the Rear Board.
Symptom: There is no output on the Call Monitor.
Reason1: A cable between the unit and a device failed.
Solution: Replace the cable.
Reason2: The Main Board is damaged.
Solution: Contact a qualified service person to replace the Main Board.
Symptom: The full screen live video display fails.
In live video mode, the Main monitor multiple screen displays as desired, but the full
screen live view of any channel fails.
Reason: The Main Board is damaged.
Solution: Contact a qualified service person to replace the Main Board.