User`s manual

Table Of Contents
User’s Manual
126 Appendices
Establishing the Dial-In Connection: PC to a DigiMux
Setting up this connection on the PC:
1. Click Start, Settings, then Network and Dial-up Connections, and click Make
new connection.
2. The Network Connection Wizard box is displayed. Click Next to continue.
3. In the Welcome to the Internet Connection Wizard box, select I want to set up my
Internet connection manually, or I want to connect through a Local Area
Network (LAN) and click Next to continue.
4. In the Setting Up your Internet Connection box, select I connect through a
phone line and a modem and click Next to continue.
5. In the Choose Modem box, select the modem on the PC that will be used to make
the connection. Make sure that no other modems are checked, then click Next to
continue.
6. In the Internet account connection information box, enter the phone number of the
modem that is connected to the DigiMux. Click Next to continue.
7. In the Internet account connection information box, enter the name and password
to be used to access the DigiMux unit. For example, you can enter muxuser in the
User Name field and muxpass in the Password field. This name and password
must match the Dial-In User Name and Dial-In Password that are set up in the
DigiMux. The default User Name is admin and the default Password is1234.
Click Next to continue.
8. In the Configuring your computer box, enter a name for your dial-in connection.
For example, you can enter To DigiMux. Click Next.
9. In the Set Up Your Internet Mail Account box, select No, and then click Next.
10. Click Finish to complete your dial-in connection.
11. Click Start, Settings, then Network and Dial-up Connections, and right-click
your new connection, i.e., To DigiMux. Select the Networking tab, and then click
Properties. Make sure that Obtain an IP address automatically is selected if you
are allowing the DigiMux unit to assign the IP address for this connection. This
option must be enabled if Auto assign Remote IP is ON (this is the default setup
in DigiMux).
If you are not allowing a remote IP assignment from the DigiMux unit, you must
enter a static IP address for this connection both in your PC and in the DigiMux
remote IP field. Click OK to exit the tab and click OK again to exit the Properties
box.