User`s manual

DigiMux
Appendices 125
9. Click Properties, then click the Callback tab. Use the default settings.
Only Do not allow callback should be selected. Click OK to exit the Callback tab,
and then click Next.
10. In the Networking Components window, make sure all boxes are checked. Select
Internet Protocol (TCP/IP) and click the Properties button.
The Incoming TCP/IP Properties window is displayed.
11. Make sure Allow callers to access my local area network is checked. Select
Specify TCP/IP addresses and enter a valid range of IP addresses in the From
and To fields. For example, in the From field, enter 192.168.000.001, and in the To
field, enter 192.168.000.253. This group of IP addresses should include the IP
addresses set up in your DigiMux Dial-In IP. See Administrator Setup, Dial In/Out,
Dial-In IP in the DigiMux OSD menu.
12. Check Allow calling computer to specify its own IP address and then click OK
to continue.
NOTE: For simplicity, this option is highly recommended.
13. In the Networking Components window, click Next to continue.
14. In the Completing the Network Connection Wizard window, you can change the
name of the connection, if desired (e.g., DigiMux). Click Finish.
Setting up this connection on the DigiMux unit:
1. Press Menu and enter your Admin passcode in the User Authorization screen.
2. From the Main Menu, select 7 Administrator Setup.
3. From the Administrator Setup menu, select 8 Dial In/Out.
4. From the Dial In/Out menu, select 5 Change Dial-Out User Name. In the
Dial-Out User Name screen, enter the user name for the above PC connection,
USER1 (or the name you assigned to the connection). Remember that the user
name is case sensitive. Select Exit or press ESC when the name is completed.
5. From the Dial In/ Out menu, select 6 Change Dial-Out User Password. In the
Change Dial-Out User Password screen, enter the password 1234 (or the
password you assigned to the connection) for the above PC connection. Select
Confirm and enter the password again. Select Confirm again or press ESC when
confirmation is complete.
6. Press ESC twice until the Main Menu is displayed, then select 5 Event Manager.
7. Select 2 Event Response, 5 Remote Notification, 6 Set up, and then 4 Dial-Out
Phone No. Enter the phone number of the modem that is connected to the PC
using the on-screen keyboard. Press ESC when complete.
8. Press ESC until the Exit menu is displayed, then select 1 Save and Exit.
The DigiMux dial-out connection to your PC is now set up.