User`s manual

User’s Manual
122 Appendices
Audio Connection
DigiMux audio requires an amplified microphone and amplified speakers. The audio
input and output are connected via RCA jacks, or an adapter for an RCA connection.
• Connect the amplified speakers to the Audio Out connector on the DigiMux rear
panel.
• Connect the amplified microphone to the Audio In connector on the DigiMux rear
panel.
IP Address Setup Information
The IP address is the identifier for your computer or device on a TCP/IP LAN or
WAN. After you connect the Ethernet cable, you set up the IP address, Netmask,
Gateway and DNS information in the OSD.
NOTE: Because the DigiMux is assigned a default IP address, you must change this
default IP address to work within your network and to avoid conflicts with other
units possibly attached to your network.
Follow these steps to set up your DigiMux on a TCP/IP network.
NOTE: The Administrator’s passcode is required to access the LAN Setup menu.
1. From the Main Menu, select Administrator Setup and press Enter.
2. From the Administrator Setup menu, select LAN Setup and press Enter.
Further address setup depends on whether or not you choose to use DHCP (Dynamic
Host Configuration Protocol).
If you are using DHCP:
DHCP is the first option on the LAN Setup menu. To select ON, press LEFT Direction
key. When you select DHCP ON, the IP address, Netmask, Gateway, and DNS settings
are retrieved from your network servers. These items on the LAN Setup menu are not
accessible when DHCP is ON.
NOTE: If you use DHCP, take note of the settings. The settings are dynamic and will
change from time to time, depending on your network’s setup. If you are using
static addressing, set DHCP to OFF.