User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
DigiMux
Maintenance 101
8. If only one device is displayed, press ENTER to begin the software update.
If multiple devices are displayed, use the Direction keys to select the device that
contains the DigiMux Software Update files. Press ENTER to confirm the selection
and begin the software update.
9. Leave the external USB device attached as DigiMux shuts down.
10. Wait at least thirty seconds.
A color bar is displayed for a few seconds before monitor output is turned off.
11. Remove the external USB device from the USB port.
12. Press 1 + ESC simultaneously and hold for 3 seconds.
This action restarts the unit.
The DigiMux unit reboots and operates the new software.
NOTE: No power interruption is allowed during the software update.
TROUBLESHOOTING
This unit has been carefully tested at the factory prior to shipping. In the event that
problems occur, see
Appendix H: Troubleshooting Guide on page 142 to perform the
corresponding verifications.
CAUTION: Do not open the unit. There are no user-serviceable parts inside.
REPAIRS
This DigiMux is a precise instrument. If treated with care, it will provide years of
satisfactory performance. However, in the event of difficulties, the user or installer is
advised not to attempt to make repairs or to open the enclosure. Servicing should be
referred to your distributor.