User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
90 System Information and Administration
Format HDD
The Format HDD menu allows the Administrator to permanently remove data from
the available hard drives. From the Administrator Setup menu, select Format HDD and
press Enter. The following screen is displayed:
Press Up/Down to move the cursor through the list of hard disk drives until the
desired drive is highlighted. Press Right/Left to specify the drive(s). YES indicates
the desired drive, NO does not. The default setting is NO.
If you connected multiple ESMs, then the screen has multiple pages. Select the next
page to add multiple ESMs to the formatting procedure.
After the drive is selected, press Up/Down to select Begin Format, then press
Right/Left to select YES and confirm the action. Press the Enter key to format the
drive.
NOTE: Formatting the hard disk completely removes the data. This data cannot be
recovered.
The message, “Format disk drive on next boot” is displayed. DigiMux performs a
complete shutdown, then formats the disk during the boot up process. It will take
several minutes to format a large hard disk drive.
Format HDD
Maxtor 4R080L0 (INT) NO
Begin Format NO
1/1