User`s manual

DigiMux
System Information and Administration 89
After the drive is selected, press Up/Down to select Begin, then press Right/Left to
select YES and confirm the action. Press the Enter key to add the drive(s).
Removing a Hard Disk Drive from your System Database
You can remove hard disk drives from the DigiMux video database, if needed.
Information stored on the drive remains on the drive, but is no longer included in the
unit’s database. For example, before you remove an ESM from your DigiMux unit,
you use the Remove HDD from Database item to ensure that the unit is no longer
using the ESM to store video.
NOTE: Be sure to follow the instructions in Disconnecting Extended Storage Module
(ESM) Units on page 128, and be sure the ESM or external hard drive
remains powered up before proceeding.
From the Database Setup menu, select Remove HDD from Database and press Enter.
The following screen is displayed:
Press Up/Down to move the cursor through the list of hard disk drives until the
desired drive is highlighted. Press Right/Left to specify the drive. YES indicates the
desired drive, NO does not. You can specify multiple drives by selecting YES for each
desired drive. The default setting is NO.
If you connected multiple ESMs, then the screen has multiple pages. Select the next
page to add multiple ESMs.
After the drive is selected, press Up/Down to select Begin, then press Right/Left to
select YES and confirm the action. Press the Enter key to add the drive(s).
Remove HDD into Database
Maxtor 4R080L0 (ESM) NO
Begin NO
1/1