User`s manual
Table Of Contents
- DigiMux User's Manual, English
- DigiMux User's Manual, English
- Table of Contents
- Overview
- System Installation
- Basic Operations
- Front Panel Controls
- Viewing Live and Playback Video Images
- Record and Playback Operation
- Recording
- Quick Record Setting Changes
- Playback Operations
- Playback Controls
- Date/Time Video Playback
- Single Step Advance and Reversing Playback Direction
- Event List Playback
- The Event List
- Event Recording and Playback
- Pre-Alarm Availability
- The Event List Display
- Playing Back Video from the Event List
- Deleting an Event from the List in Playback Mode
- Deleting a Page from the Event List
- Covert Cameras
- Dome Control
- Dome Control Signals Installation
- Basic Alarm Features
- Advanced Operations
- System Information and Administration
- Maintenance
- Glossary
- Appendices
- Appendix A: Account Access and Priorities
- Appendix B: Connector Pin Assignments
- Appendix C: Technical Specifications
- Appendix D: Optional Connections and Installation
- Optional Connections
- Audio Connection
- IP Address Setup Information
- Dial-Up Connections via Modem
- Establishing the Dial-Out Connection: DigiMux to a PC
- Establishing the Dial-In Connection: PC to a DigiMux
- Using the Dial-Up Connections
- Connecting Extended Storage Module (ESM) Units
- Disconnecting Extended Storage Module (ESM) Units
- Additional Installation Information
- Appendix E: DigiRemote
- Appendix F: DigiMux Digital Signatures
- Appendix G: Using ControlCenter 200/300 Keyboards
- Appendix H: Troubleshooting Guide
- Index
User’s Manual
88 System Information and Administration
Items in the Database Setup menu are described in the following table:
Adding a Hard Disk Drive to your System Database
You can add hard disk drives to the DigiMux video database to extend the storage
capabilities of the unit. For example, an Extended Storage Module (ESM) can be
connected to the IEEE-1394 FireWire
®
connector on the rear panel for storage space.
The Add HDD into Database menu item allows the unit to add the drive and begin
storing additional video information on the drive.
NOTE: Be sure to follow the instructions in Connecting Extended Storage Module (ESM)
Units on page 128, and be sure the ESM or external hard drive is powered up
before proceeding.
From the Database Setup menu, select Add HDD into Database and press Enter. The
following screen is displayed:
Press Up/Down to move the cursor through the list of hard disk drives until the
desired drive is highlighted. Press Right/Left to specify the drive. YES indicates the
desired drive, NO does not. You can specify multiple drives by selecting YES for each
desired drive. The default setting is NO.
If you connected multiple ESMs, then the screen has multiple pages. Select the next
page to add multiple ESMs.
MENU ITEM DESCRIPTION
Add HDD into Database Allows you to add hard disk drives into the
video database for storage. See
Adding a Hard
Disk Drive to your System Database on page 88
Remove HDD from Database Allows you to remove hard disk drives from
the video database.
Format HDD Allows you to format the hard disk(s).
Formatting removes all saved data. See
Format
HDD on page 90.
Add HDD into Database
Maxtor 4R080L0 (ESM) NO
Begin NO
1/1