User`s manual

DigiMux
System Information and Administration 85
Dial-In IP
Modem communication with DigiMux takes place via the Point to Point (PPP)
protocol. The Dial-In IP menu allows you to enter the IP addresses that enable the
DigiMux unit to communicate with a remote PC via a modem. From the Dial In/Out
menu, select Dial-In IP and press Enter. The following menu is displayed
Items in the Dial-In IP menu are described in the following table:
The Local IP address identifies the DigiMux unit over the modem line. By default, the
DigiMux automatically assigns an IP address to the remote PC to establish a
connection with it.
Change Dial-Out
User Password
Enables you to enter your PC log in password, which is used
while dialing out to your remote PC.
Modem Allows you to enable a connected modem and to enter
parameters that DigiMux requires for dialing out via the
specified modem. See
Items in the Dial-In IP menu are described in
the following table: on page 85.
MENU ITEM DESCRIPTION
Dial-In IP
1 Local IP 192.168.000.001
2 Auto assign Remote IP ON
3 Remote IP 192.168.000.002
MENU ITEM DESCRIPTION
Local IP Assigns the IP address that identifies the DigiMux unit over the
modem connection. The default Local IP is 192.168.000.001. This
address can remain as is unless it conflicts with another IP
address.
Auto assign
Remote IP
Enables (ON) or disables (OFF) automatic assignment of an IP
address to the remote PC. A Windows Operating System default
connection specifies that the DigiMux unit assign the IP address
to the PC. If you are using this default connection, then enable
(ON) this item. Otherwise, select OFF.
Remote IP Specifies the remote PC’s IP address for connection with the
DigiMux unit, if the DigiMux unit is not making the assignment.
Use the Arrows to enter the IP address and press Enter to accept
it. This item is only available if Auto assign Remote IP is OFF.