Specifications

Chapter 5 — Operation 25
Live Mode Without Record
Live mode is used for viewing a multicamera image on the
main monitor. No recording takes place while in live mode.
The LIVE LED is lit.
The on-screen record status message (if set ON in the Setup
menu) flashes REC OFF.
The RECORD and TAPE LEDs are off.
Pressing the LIVE button displays the images from multiple
cameras. You can change the position of each camera on the
monitor by pressing and holding a display format button (2x2,
3x3 or 4x4), while pressing camera buttons in the order you
prefer. To see a 2x2 display with cameras 4, 2, 3 and 1, you
would press and hold the 2x2 button, while pressing CAM-
ERA buttons 4, 2, 3 and 1.
Pressing a CAMERA button shows the selected camera image
displayed full screen on the monitor. If the CALL LED is off,
the camera displays on the main monitor. If the CALL LED is
lit, the camera displays on the call monitor. To change which
monitor displays a camera, press the CALL button, then the
CAMERA button.
Pressing sequence (up arrow) shows a full-screen sequence
of camera images at the programmed dwell rate.
Press VCR VIEW if you need access to the VCR programming
menus.
In live mode, nothing is sent to the VCR and motion is NOT
detected.
Alarms A full-screen live display of the camera associated with the
alarm is shown on the main and call monitors. An ALARM
message will also show on the main monitor above the camera
number (unless the ALARM MESSAGE DISPLAY menu op-
tion is OFF). If multiple alarms occur, a sequence of full-screen
images from each alarm camera will display on both monitors.