Operator`s manual

Running Patterns
Patterns are sequential series of pan, tilt, zoom,
and focus movements from a single programmable
dome. You “teach” the dome a combination of
these movements that can be replayed
automatically.
Note: Most SpeedDome series domes support 3
patterns. SpeedDome LT does not support
patterns, but uses Pattern 1 for the auto pan
function.
1. Select the camera whose Pattern you want to
run.
2. Enter the Pattern number (1-3), and then do
one of the following:
• Press Pattern to run the pattern one time
and stop.
• Press Repeat Pattern to run the pattern
indefinitely.
Note: To stop a pattern, issue a camera command
(pan, tilt zoom or focus) to the dome running the
Pattern.
Running the Controller
Sequence
The Controller Sequence is a collection 16 Quick
Views, Patterns, and fixed shots, that play one
after the other on the Main monitor. It provides a
broad surveillance of a facility.
To initiate the pre-defined Sequence, press Seq.
The Sequence repeats indefinitely until you press
Seq or Clear.
Control Dome Outputs
Use a copy of the Inputs/Outputs Worksheet to
determine which output you want to control.
1. Enter the camera number and press
to
select the dome.
2. Enter the output number (1-4), and press
Output On or Output Off.
• Output On activates the output.
• Output Off deactivates the output.
Clearing Alarms
Press Clear to acknowledge the alarm whose
information appears on the LCD. Up to four alarms
may be queued on the controller.
Note: If Automatic Alarm Acknowledgement is
enabled, the alarm clears after a 60 seconds.
Advanced System Operation
IMPORTANT! Some advanced functions are only
available on the primary controller.
Working in Menu Mode
Press Menu to switch the controller to menu mode.
This mode allows you to program features and
configure controller settings. When menu mode is
active:
• Use the Tracker Ball to scroll through the
menu.
• Press Zoom to select menu item appearing on
the first line of the LCD.
• Press Focus to select the menu item appearing
on the second line of the LCD.
Programming Quick Views
1. Select the camera where the Quick View will
be saved.
2. Adjust the pan, tilt, zoom and focus settings for
the camera until the scene you want to save
appears on the monitor.
3. Press Menu.
4. Scroll through the menu until Setup View is
displayed on the LCD. Press Zoom or Focus
to select.
5. Enter View#? appears on the LCD. Enter the
view number (1-96), then press Zoom, Focus
or View to save.
View Saved appears briefly on the LCD.
ADTT16E ADVANCED DOME CONTROLLER 8200-0306-03, REV. A1
QUICK REFERENCE GUIDE
3 of 7