Operator`s manual

Multiplexer Live Mode Problems
Problem Description Possible Solution
All LIVE pictures too
bright, too dark, or
incorrect color.
st the
multiplexer gray bars.
• The monitor may not be properly adjusted. Adju
Some LIVE pictures too
dark.
• The camera iris may not be correctly adjusted. Adjust
the camera iris using a calibrated monitor
Multiplexer Tape Mode Problems
Problem Description Possible Solution
Poor or unstable pictures. • The VCR may be faulty or require maintenance.
Perform periodic maintenance and test VCR
performance.
VCR not recording. • Make sure the VCR is connected to an electrical
receptacle and is turned on.
• Make sure a tape cartridge is inserted into the VCR.
Multiplexer Motion Detection Problems
Refer to the Multiplexer Operator's Manual for information about changing these settings.
Problem Description Possible Solution
Important camera motion
not detected.
• Required camera motion targets may be turned off.
Perform the motion detection setup and turn on the
required motion targets.
• Motion detection sensitivity may be too low. Adjust
the motion sensitivity setting.
• Delay setting is too long. Adjust the delay setting.
Unimportant camera
motion detected.
• Unnecessary camera motion targets may be turned
on. Perform the motion detection setup and turn off
the undesired motion targets.
• Motion detection sensitivity may be too high. Adjust
the motion sensitivity setting.
• Delay setting is too short. Adjust the delay setting.
6-12 ADTT16E Advanced Dome Controller Operator's Manual