Operator`s manual

Working with Freeze Frame and Freeze Field Modes
The Quest multiplexer supports the ability to freeze the current image on-screen. This is
useful if you need to briefly stop the live image to write pertinent information about a
situation or zoom into the image. For example, you may want to log license plate numbers
for vehicles entering a parking garage.
Two freeze modes are available: Freeze Frame and Freeze Field. Freeze Frame is useful for
static images with little motion. Freeze Field is useful for images with motion. Press C on
the controller to switch between Freeze Frame and Freeze Field modes.
Working with the Multiplexer Sequence
The Quest multiplexer supports three sequences. The number of “pages” displayed, the dwell
time between pages, and the screen display format can be programmed using the controller.
• Press A (left of LCD display) to activate multiplexer sequence mode. Each time you
press A, you switch to the next available sequence.
• Press
to start sequence programming for the currently displayed sequence. Follow
the instruction in Multiplexer Sequence Programming to program the selected
multiplexer sequence.
• If no button is pressed, the displayed sequence begins. To exit from multiplexer sequence
mode, press D.
Multiplexer Sequence Programming
1. Press A until the sequence you want to program appears on screen. Seq1, Seq2, or
Seq3 appears in the upper left corner of the screen.
2. Press
to start programming mode. The sequence setup screen appears.
Figure 5-5: Sequence Setup Screen
Sequence
_
1 Set Up
1 Pages 16 11 Page 8
2 Mode 1 12 Page 9
3 Timer 5 13 Page10
4 Page1 14 Page11
5 Page2 15 Page12
6 Page3 16 Page13
7 Page4 17 Page14
8 Page5 18 Page15
9 Page6 19 Page16
10 Page7 20 Exit
Number of pa
g
es in
sequence
Selected
Sequence
Window displa
y
format
Dwell time
for pa
g
es
Exit programming
and run sequence.
Quest Multiplexer Support 5-7