Operator`s manual

Programming Quick Views
A Quick View is a programmed video scene based on specific pan, tilt, zoom, and focus
settings for a programmable dome. Program Quick Views if you need to frequently observe
specific locations, such as entrances, lobbies, or loading docks. Presets and Targets are other
names used for Quick Views.
When accessed, the Quick View automatically calls up the scene for the selected dome,
regardless of where the dome is currently pointing. Either four or 96 Quick Views may be
programmed, depending on the programmable dome type.
Quick View Programming Instructions
1. Select the camera where the Quick View will be saved.
2. Adjust the pan, tilt, zoom and focus settings for the camera until the scene you want to
save appears on the monitor.
3. Press Menu.
4. Scroll through the menu until Setup View is displayed on the LCD. Press Zoom or
Focus to select.
Tip: Zoom selects the first line; Focus selects the second line.
5. Enter View#? appears on the LCD. Enter the view number (1-96), then press Zoom,
Focus or View to save. View Saved appears briefly on the LCD.
Note: The controller beeps if an invalid Quick Viewer number is entered. If this happens,
enter a valid number, and the Quick View will be saved.
The controller automatically returns to the camera control mode after saving the Quick
View. Make a record of the Quick View, including the camera number and a brief
description in the Programming Worksheets (8200-0306-04).
Programming Time Saver
To quickly program a Quick View, first adjust the camera to the desired scene.
Press Menu, and then press View. You will be prompted to assign a View
number. Enter the Quick View number (1-96), and press Zoom, Focus, or
View to save.
4-2 ADTT16E Advanced Dome Controller Operator's Manual