Operator`s manual

Running Patterns

IMPORTANT

The SpeedDome LT supports a feature called “Auto Pan” that allows you to

program a smooth side-to-side camera movement for an area. See Chapter 4

for additional information.

A Pattern is a sequential series of pan, tilt, zoom, and focus movements from a single

camera. You “teach” the camera a combination of these movements. Whenever the Pattern is

run, the camera automatically recalls the movements it was taught. Patterns can be run once

or run repeatedly until manually stopped. Most programmable domes support up to three

Patterns defined for it. The SpeedDome LT will support programming the Auto Pan feature

for Pattern 1; it does not support programming any additional patterns. Figure 3-11 illustrates

the locations of the Pattern and Repeat Pattern buttons.

Figure 3-11: Pattern and Repeat Pattern buttons

789

Pattern

Repeat

Pattern

View

Flip

Peel

Info

Off

Output

Clear

Iris

Open

Enter Pattern number

and press to run the

Pattern one time.

Enter Pattern number

and press to run the

Pattern continuously.

Chapter 4 provides Pattern programming instructions. If a list has been compiled for your

facility, refer to the Programming Worksheets (8200-0306-04) to determine which Patterns

are available for the installed domes.

Operating the ADTT16E Advanced Dome Controller 3-13