Operator`s manual

SpeedDome Peel and Flip Features

The SpeedDome series camera domes support two special features called Apple Peel and

Flip. Pressing the appropriate buttons on the controller automatically activate these features.

Figure 3-8 illustrates the location of the Peel and Flip buttons.

Figure 3-8: Peel and Flip buttons

789

Pattern

Repeat

Pattern

View

Flip

Peel

Info

Off

Output

Clear

Iris

Open

Press to run the

default SpeedDome

pattern.

Press to rotate the

SpeedDome 180°

Running the “Apple Peel” Pattern

The Apple Peel pattern consists of three revolutions of camera panning (with tilt) starting at

the ceiling line. Each revolution tilts down approximately 30°. The Apple Peel pattern

provides you with a complete view of the area. Figure 3-9 illustrates the Apple Peel pattern

movement.

Figure 3-9: Apple Peel Pattern

Select the camera and press Peel to run the Apple Peel pattern. The Apple Peel pattern

repeats indefinitely until a camera command (pan, tilt, zoom, focus, or iris) is issued to the

camera. The following message displays on the LCD while the Apple Peel pattern is

running:

Cam 16 +

le Peel Patn

Note: If the ADTT16E controller is used with a Sensornet-to-RS-422 Code

Converter

and Pattern 3 has been programmed, pressing Peel runs Pattern 3.

Operating the ADTT16E Advanced Dome Controller 3-11