Installation guide

ADTT16E ADVANCED DOME CONTROLLER 8200-0306-01, REV. C
INSTALLATION GUIDE 9 of 14
Installing with Intellex 2.x DVMS and Newer
P1
P2
P3
P4
P5
P6
P8
J-Box #1
To Dome
Refer to instructions
included with device.
EIM #1
SensorNet A
SensorNet B
RJ45
DB9M
Terminated
J-Box P1-P6
Color Pin Function
Orange 1 SensorNet A
White 2 28 Vac
Red 3 Ground
Black 4 28 Vac
Yellow 5 SensorNet B
J-Box P8
Color Pin Function
Orange 1 Host A
Yellow 2 Host B
Orange 3 Auxiliary A
Yellow 4 Auxiliary B
RJ45
Primary
Touch Tracker
Intellex 2.x or newer
(with DB9 connector)
EIM Transformers
Note:
The maximum combined
SensorNet cable length is
1000 m (3000').
Note:
Your system supports two
controllers. Terminate E1 on
the EIM that is on the end of
the SensorNet Network.
DB9F connect
to COM2
Straight-Thru Cable
(
RPNR00
)
Straight-Thru Cable Wiring
EIM DB9F COM 2
2 Tx 2 Rx
3 Rx 3 Tx
5 Ground 5 Ground
COM 2
DB9 Connecto
r
Call monitor feature board
is used if Secondary Touch
Tracker is installed.
EIM #2
Secondary
Touch Tracker
Unterminated
24 Vac B
RJ45
RJ45
24 Vac B
Ground
24 Vac A
24 Vac A
Ground
Note:
Intellex back panel may look
different depending upon the
model. All newer Intellex systems
will connect to COM2.
For older models, contact support.