Installation guide

ADTT16E ADVANCED DOME CONTROLLER 8200-0306-01, REV. C
INSTALLATION GUIDE 6 of 14
Installing with RJ11 Connection Multiplexer
Note:
Your system supports two
controllers. Terminate E1 on
the EIM that is on the end of
the SensorNet network.
RJ11
Connects to
Remote In
To Dome
Refer to instructions
included with device.
J-Box #1
J-Box P1-P6
Color Pin Function
Orange 1 SensorNet A
White 2 28 Vac
Red 3 Ground
Black 4 28 Vac
Yellow 5 SensorNet B
EIM #1
EIM #2
SensorNet A
SensorNet B
J-Box P8
Color Pin Function
Orange 1 Host A
Yellow 2 Host B
Orange 3 Auxiliary A
Yellow 4 Auxiliary B
RJ45
RJ45
RJ45
RJ45
Secondary
Touch Tracker
Primary
Touch Tracker
DB9M
24 Vac A
24 Vac B
Ground
24 Vac A
24 Vac B
Ground
Unterminated
Terminated
EIM DB9 Wiring
Color Pin Function
Red 2 Transmit
Black 5 Ground
Note: Pin 3 is not used; do not
connect it.
Multiplexer (with RJ11 Connector)
Multiplexer Interface Cable
6003-0108-01
EIM Transformers
Note:
The maximum combined
SensorNet cable length is
1000 m (3000 ft).
RJ11