Installation guide

ADTT16E ADVANCED DOME CONTROLLER 8200-0306-01, REV. C
INSTALLATION GUIDE 12 of 14
Configuring the External
Device
Use this procedure to select the external device
that connects to the advanced dome controller.
1. From the primary controller, press Menu to
configure the software for the external system.
The menu appears on the LCD.
2.
Scroll through the menu items until
Config Devices
appears on the LCD screen.
Press Zoom or Focus to select.
3. Press Next to scroll through the available
devices. Refer to the following chart to
determine which device to select.
Device Setting Use with...
Device=Quad
=POSEM
Quad Splitter with DB9F-RJ45
connection
Device=Mux 4
=POSEM
Standard 4-camera Multiplexer,
dual page Quad Splitter, and
Quad Splitter (RVQX7X)
Device=Mux 9
=POSEM
Standard 9-channel multiplexer
Device=Mux 16
=POSEM
Standard 16-channel multiplexer
and Intellex
Device=Mux 4
=Duplex
4-channel Quest Duplex
multiplexer
Device=Mux 9
=Duplex
9-channel Quest Duplex
multiplexer
Device=Mux 16
=Duplex
16-channel Quest Duplex
multiplexer.
Device=Mux 10
=Triplex
10-channel Quest Triplex
multiplexer
Device=Mux 16
=Triplex
16-channel Quest Triplex
multiplexer.
PC
Reserved for service use.
Remote
Use this option if the Touch
Tracker is installed at a remote
location and communicates at
1200 baud.
None
No external device is
connected.
4. When the correct configuration appears on the
LCD, press Menu.
Continue with Setting Primary and Secondary
Unit.
Setting Primary and
Secondary Unit
NOTE: Quad Splitter, Intellex 1.x and 2.0, and
stand-alone installations support only one
controller.
If you have two advanced dome controllers
installed, one must be designated as Primary; the
other must be designated as Secondary. If you
have only one controller installed, it must be
designated as Primary.
1. Press Menu.
2.
Scroll through the menu items until Tog
Primary/2nd appears on the LCD. Press
Zoom or Focus to select.
3. Press Next to toggle between setting the
controller as primary or secondary. When the
appropriate choice appears on the LCD, press
Menu. The controller will reset.
Repeat this procedure for each advanced dome
controller.