Specifications

SECURITY CAMERA SYSTEM UPGRADE AND REPLACEMENT
FOR MONTGOMERY COUNTY DETENTION CENTER
GENERAL CONDITIONS GC-11
are required the way the Contractor proposes to conform to the information given and the design
concept expressed in the Contract Documents. Review by the Engineer and Board is subject to the
limitations of Subparagraph 4.1.7.
3.11.5 The Contractor shall review, approve and submit to the Engineer and Board Shop Drawings,
Product Data, Samples and similar submittals required by the Contract Documents with reasonable
promptness and in such sequence as to cause no delay in the Work or in the activities of the Board
or of separate contractors. Submittals made by the Contractor which are not required by the
Contract Documents may be returned without action.
3.11.6 The Contractor shall perform no portion of the Work requiring submittal and review of Shop
Drawings, Product Data, Samples or similar submittals until the respective submittal has been
approved by the Engineer and Board. Such Work shall be in accordance with approved submittals.
3.11.7 By approving and submitting Shop Drawings, Product Data, Samples and similar submittals,
the Contractor represents that the Contractor has determined and verified materials, field
measurements and field construction criteria related thereto, or will do so, and has scheduled and
coordinated the information contained within such submittals with the requirements of the Work and
of the Contract Documents.
3.11.8 The Contractor shall not be relieved of responsibility for deviations from requirements of
the Contract Documents by the Board's or Engineer's approval of Shop Drawings, Product Data,
Samples or similar submittals unless the Contractor has specifically informed the Board and the
Engineer in writing of such deviation at the time of submittal and the Board and the Engineer have
given written approval to the specific deviation. The Contractor shall not be relieved of
responsibility for errors or omissions in Shop Drawings, Product Data, Samples or similar submittals
by the Board's or the Engineer's approval thereof.
3.11.9 The Contractor shall direct specific attention, in writing or on resubmitted Shop Drawings,
Product Data, Samples or similar submittals, to revisions other than those requested by the Engineer
or Board on previous submittals.
3.11.10 Informational submittals upon which the Board and Engineer are not expected to take
responsive action may be so identified in the Contract Documents.
3.11.11 When professional certification of performance criteria of materials, systems, or
equipment is required by the Contract Documents, the Contractor shall provide the person or party
providing the certification with full information on the relevant performance requirements and on
the materials, systems, or equipment that are expected to operate at the Project site.
3.11.12 All Shop Drawings for any Engineering, structural, mechanical or electrical work
must be submitted to, and approved by the Engineer and Board. The Contractor represents and
warrants that all Shop Drawings shall be prepared by persons and entities possessing expertise and
experience in the trade for which the Shop Drawing is prepared and by a licensed professional if so
required by the Engineer, Board or applicable law.