Specifications

SECURITY CAMERA SYSTEM UPGRADE AND REPLACEMENT
FOR MONTGOMERY COUNTY DETENTION CENTER
SECURITY CAMERA SYSTEM 17000-85
G. The housing must offer an optional thermostatically controlled pad heater and
automatically regulate its output to provide heat in the housing and maintain a
clear viewing window. The heater shall operate with either 24 VAC or 24 VDC
supply voltages.
H. The housing must offer an optional thermostatically regulated 24 VAC blower.
I. Two weatherproof glands must be provided on the bottom of the housing for
cable entry.
J. The camera housing must have a light gray epoxy finish.
K. The housing must be secured from unauthorized entries by the use of tamper
resistant screws.
L. Optional wall or ceiling mounts must be available for the camera housing. The
mounts must have a weight load capacity of no less than 9.1 Kg (20 lbs.), and
have a light gray finish to match the camera housing. The mounts shall be
suitable for indoor or outdoor applications.
M. The camera housing shall be an American Dynamics AD1314 Series or
equivalent.
N. Minimum Performance Specifications: The camera housing must meet the
following requirements:
1. Mechanical
Construction:
Housing: Magnum® 941 Polymer
Viewing Window: 4.8 mm (.19 in) Lexan®
Finish: Epoxy
Color: Light gray
Dimensions (H x W x L): 141 x 159 x 449 mm (5.56 x 6.2 x
17.68 in)
Unit Weight:
Without sunshield: 1.8 Kg (4.0 lbs.)
With sunshield: 3.2 Kg (7.0 lbs.)
Cable Entry: 2 weatherproof glands
Max. Camera/Lens Length: 304.8 mm (12.0 in)
Camera Mounting: Non-metallic multi-position front to
back adjustment
Heater Kit:
Type: Thermostatically controlled pad
heater
Supply Voltage: 24 VAC/VDC (12-30V)
Power: 0.63 A maximum