Specifications

SECURITY CAMERA SYSTEM UPGRADE AND REPLACEMENT
FOR MONTGOMERY COUNTY DETENTION CENTER
SECURITY CAMERA SYSTEM 17000-24
2. Note: This project is an addition to an existing security network. For this
reason, all product brands/manufactures used on the existing security
network must be used on the new system additions unless specifically
changed in these specifications. Refer to the separate sections for specific
brands and manufactures.
3. SHOP DRAWINGS: Prior to purchase, fabrication and installation,
prepare and submit shop drawings of work to Engineer for approval
thereof. Shop drawings shall be based on drawings, specifications and
field conditions and/or measurements essential for proper fitting of system
components with other construction and shall present complete
information as to fabrication and erection.
4. CATALOG DATA: Prior to purchasing, submit complete catalog data and
descriptive literature of specified items to Engineer and obtain approval
thereof. Include installation drawings as required.
5. SAMPLES: Prior to purchase or fabrication, submit two samples of each
type and/or color of factory finish of each material specified and obtain
Engineer's approval thereof.
6. QUALITY CONTROL: Conform to the requirements for Quality Control
under Genera! Conditions where same governs the materials and
procedures described under this Section.
7. RECORD "AS-BUILT' DRAWINGS: The Contractor shall, during the
progress of the work, keep accurate data on locations and elevations of
the work and any changes to the drawings and/or specifications so that
he can record this information in the required ''as- built" record drawings.
This information must be promptly recorded by the Contractor throughout
the progress of the work so that the record set maintained by the
Contractor is always current with the work accomplished to date.
8. GUARANTEE: Contractor shall submit written guarantee stating that all
work under this Section shall be guaranteed against any defects in
materials and/or workmanship during the guarantee period and that
defective work which develops during guarantee period shall be repaired
and/or replaced at no additional cost to the Owner. Section 17000-3.13 E
describes the Guarantee and Service/Maintenance requirements to be
included in the base bid.
G. Existing Systems Description:
1. Current Security System/Network – Component hardware/software
a. Wonderware version 7.0
b. There are a total of 8 Wonderware HMI projects