Specifications

SECURITY CAMERA SYSTEM UPGRADE AND REPLACEMENT
FOR MONTGOMERY COUNTY DETENTION CENTER
SECURITY CAMERA SYSTEM 17000-15
V. Equipment Identification:
1. In addition to the requirements of the National Electrical Code, install an
identification sign which will clearly indicate information required for use
and maintenance of items such as cabinets, control devices and other
significant equipment.
2. Nameplates shall be laminated black phenolic resin with a white core and
engraved lettering, a minimum of 1/4-inch high. Nameplates that are
furnished by manufacturer, as a standard catalog item, or where other
methods of identification is herein specified, are exceptions.
W. Surface Conditions:
1. Prior to any Work, the Contractor shall carefully inspect the installed
Work of all other Trades and verify that all such Work is complete to the
point where his installation may properly commence.
2. Verify that all equipment may be installed in accordance with. all
pertinent codes and regulations, the original design, and the referenced
standards.
3. In the event of discrepancy, immediately notify the Engineer.
4. Do not proceed with installation in areas of discrepancy until such
discrepancies have been fully resolved.
5. Return to original (pre-construction) condition any paved areas, sidewalks,
planting, etc., disturbed during system installation.
X. Installation:
1. Install all equipment in strict accordance with the manufacturer's
recommendations and reviewed shop drawings.
2. Secure equipment using fasteners suitable for the use, materials, and loads
encountered. If requested, submit evidence proving suitability. Do not
attach electrical materials to roof decking, removable or knockout panels,
or temporary walls and partitions, unless indicated otherwise.
3. Equipment location: Shall be as close as practicable to locations shown
on drawings.
4. Working spaces shall be not less than specified in the National Electrical
Code for all voltages specified.
5. Where the Engineer determines that the Contractor has installed
equipment not conveniently accessible for operation and maintenance,
equipment shall be removed and reinstalled as directed at no additional