Specifications

SECURITY CAMERA SYSTEM UPGRADE AND REPLACEMENT
FOR MONTGOMERY COUNTY DETENTION CENTER
SECURITY CAMERA SYSTEM 17000-9
4. All welders shall be certified by the Welding Bureau of the Mechanical
Contractors Association of America for the appropriate service, and shall
perform all welding in accordance with the Welding Bureau's procedures
and the ASA Code for welding.
O. Cooperation With Other Trades:
1. The Contractor shall coordinate the Work of this Section with that of
other Sections as required to ensure that the entire work of this Project
will be carried out in an orderly, complete and coordinated fashion.
Bidders are cautioned to check their equipment against space available as
indicated on drawings, and shall make sure that proposed equipment can
be accommodated. If interferences occur, Contractor shall bring them to
the attention of Engineer, in writing; or, Contractor shall, at his own
expense, provide proper materials, equipment, and labor to correct any
damage due to defects in his work caused by such interferences.
P. Submittals:
1. "OR EQUAL" CLAUSE: Notwithstanding any reference in the
specifications to any article, device, product, material, fixture, form or
type of construction by name, make, or catalog number, such references
shall be interpreted as establishing a standard of quality.
2. Approvals and Substitutions:
a. Request for approvals and substitutions will be considered only if
submitted in accordance with procedures outlined in the Special
Conditions, regarding prior approval, and equipment and material
approvals and substitutions.
b. Any additional materials, equipment, components, accessories, etc.
items required for the satisfactory installation of approved
substitute equipment shall be furnished and installed at no
additional cost to the Owner. This includes but shall not be
limited to changes to branch circuits, circuit protective devices,
conduits, wire, feeders, controls, panels and correlation with other
work, subject to the approval of the Engineer.
3. Verification of Dimensions, Etc.
a. The Contractor shall visit the premises and thoroughly familiarize
himself with all details of the work, working conditions, verify all
dimensions in the field, advise the Engineer of any discrepancy,
and submit shop drawings of any changes he proposes to make.
in quadruplicate for approval. before starting the work. Contractor
shall install all equipment in a manner to avoid building
interference.