Specifications

SECURITY CAMERA SYSTEM UPGRADES AND REPLACEMENTS
FOR MONTGOMERY COUNTY DETENTION CENTER
ELECTRICAL 16000-6
E. Submittals shall be itemized on a standardized shop drawing submittal form
stating the name of the project, specification section, paragraph and/or drawing
numbers applicable to submittal and shall bear the contractor's review stamp as
evidence that the items have been initially checked for compliance with Contract
Documents as stated above.
F. After review, shop drawings will be returned marked in one of the following
ways:
1. "NO EXCEPTIONS NOTED" - Copies may be distributed as required for
construction, shipment, etc. to proceed.
2. "EXCEPTIONS NOTED" - Contractor may proceed with and/or authorize
construction, shipment, etc. taking into account the necessary corrections.
3. "EXCEPTIONS NOTED - REVISE AND RESUBMIT" - Contractor will
be required to resubmit shop drawings in their entirety. No fabrication,
erection or installation shall be authorized or initiated until shop drawings
so marked have been completely revised, resubmitted and subsequently
marked in accordance with either of the two preceding subparagraphs.
Only shop drawings officially marked "NO EXCEPTIONS NOTED" or
"EXCEPTIONS NOTED" will be permitted on the jobsite.
G. Upon return of submittals take appropriate action as specified above. Note that
any shop drawing copies received beyond the number required will be destroyed
(not returned). Also note that if an insufficient number of copies has been
submitted, no review will take place until all required copies have been received.
H. Where resubmittal is required, four (4) copies will be so noted by the reviewer,
of which two (2) copies will be returned for corrections (one (l) copy for the
contractor and one (l) copy for the supplier/subcontractor).
I. The following is a list, where applicable, of items requiring submittals.
1. Panelboards
2. Lighting fixtures, Lamps, and Ballasts
3. Wiring Devices and Cover Plates
4. Battery Powered Emergency Lighting Units
5. Fire Alarm and Detection System
J. Note that submittal review is for general construction, detailing and application
only. Carefully check and verify dimensions for installation, clearance and
service requirements before ordering equipment for the project. At completion
the subsequent installation shall be such that all equipment will function and be
serviceable in a normal and satisfactory manner.
K. Shop drawings will be provided by the Owner for any Owner furnished
equipment requiring service or connections under this section.
L. A complete set of shop drawings, officially marked in the prescribed manner
noted previously, shall be filed on the job site. Such drawings shall be kept
together, maintained in good condition and shall be readily available for
reference.