Specifications

SECURITY CAMERA SYSTEM UPGRADES AND REPLACEMENTS
FOR MONTGOMERY COUNTY DETENTION CENTER
ELECTRICAL 16000-3
have not been installed and the revised location is not greater than 10 feet from
the location indicated.
D. Note also that electrical connections indicated on the drawings may not be shown
in the correct location for the equipment, fixtures, devices, etc., actually selected
for the project. Verify all connection locations with shop drawings of the item
to be installed or make field measurements before proceeding with any rough-in
work.
E. The general building and/or structural drawings shall be used to obtain
dimensions and exact locations and as a check with other contractors to avoid
interference with their work. Refer to applicable drawings on all branches of the
work where other trades are involved on the project so that added field work
and/or job delays resulting from conflicts between crafts can be avoided.
7. SPECIFICATIONS
A. Specifications shall be interpreted in conjunction with the drawings hereinbefore
described and if anything is shown on the drawings and not mentioned in the
specifications or vice versa, it is to be included in the work the same as though
clearly set forth by both.
B. Furthermore, all materials or labor obviously required to fully complete the work
shall be included in the bid, even though each item necessarily involved is not
specifically mentioned or shown. Such work and/or material shall be furnished
and shall be of the same grade or quality as the parts actually specified and
shown. Should there be a conflict between the plans and specifications, the
greater quantity or better quality shall be furnished.
C. Should an overlap of work between the various trades become evident, the
Engineer shall be notified. Such an event shall not relieve any trade of the
responsibility for the work called for under his branch of the specifications until
a written clarification or directive is issued concerning the matter.
D. When selecting equipment to be used on this project, refer to Item EQUIPMENT
CLEARANCES AND REQUIREMENTS in these specifications.
E. Note that all systems and items of equipment involved under this contract
heading shall be furnished and installed in accordance with applicable
requirements of federal, state and local codes including the ADA (Americans
with Disabilities Act), OSHA requirements and applicable portions of NFPA.
The above includes adhering to applicable requirements governing mounting
heights for occupant operable controls.
F. All references made to codes, standards, etc. in these specifications or on the
drawings shall be taken to mean the latest edition, amendment and/or revision of
such reference in effect as of the date indicated on the Bid Documents.
8. MATERIALS AND WORKMANSHIP
A. Materials supplied under this contract shall be new and in strict accordance with
the provisions of these plans and specifications. Any material required which is
not specifically represented by a manufacturer's catalog number of quality
standard, shall be subject to the approval of the Architect/Engineer in all cases.