Specifications

ENGLISH
Camera mounting holes (1/4 inch)
This screw hole is used to install the camera on a mount to
PAN/TILT UNIT.
Camera mounting bracket locking screws ( x 2 : M2.6 x 5mm)
Do not use any screw longer than 5 mm.
Camera mounting bracket
The camera mounting bracket is mounted on the bottom of
the camera at the factory. It can be installed on the top of the
camera if necessary. Fit the mounting bracket on the top of
the camera head with the two screw
.
Backfocus adjustment ring
This ring both allows the adjustment of the backfocus to and
switch as the lens mounting method between C and CS.
Loosen the BF LOCK screw
by turning it counterclockwise
before turning this ring, and be sure to secure screw
by
turning it clockwise after turning this ring. This camera has
been adjusted to the optimum position for the C mount before
shipment.
[BF LOCK] Backfocus locking screw
This screw locks the backfocus adjustment mechanism.
Lens mount
The lens mount is compatible with C-mount lenses (1/2 and 2/
3 inch) and CS-mount lenses (1/2 inch).
[DC IRIS] DC iris connector
Connect to an auto-iris lens which does not incorporate an EE
amplifier. (See “Lens” on page 14.)
Controls, connectors and indicators
7
2
1
3
4
6
5
4