Specifications

ENGLISH
10
Notes:
• When AGC GAIN is set to 9 or 18 dB or when SUPER AGC is
set to ON, dark parts of the picture may look noisy. This is be-
cause sensitivity increased and it is not a malfunction.
• With SUPER AGC set to ON, the level reaches 18 dB even with
AGC GAIN at 0 or 9 dB. AGC GAIN display does not change
however.
• The camera ID level can be adjusted by turning SUPER AGC on
and off.
• The response of the SUPER AGC may be retarded against the
acute level changes.
<Setting in MANUAL mode>
1. Press SET button in MANU ( 1/50 [1/60] ) mode, and ( ) are
removed to allow setting.
2. Change the shutter speed with
or button.
3. Press SET button again, and ( ) comes out to finish shutter
speed setting.
If the AUTO mode or a high-speed shutter mode is selected under
fluorescent lighting, the picture could flickering or the white bal-
ance could be un-stable.
Set according to whether the electronic
shutter is to be switched manually or au-
tomatically.
• MANUAL : 1/50 [1/60] s, 1/120 [1/100]s,
1/250s, 1/500s, 1/1000s,
1/2000s, 1/4000s, 1/10000s.
• AUTO : 1/50 [1/60] - 1/100000s
Variable range
Initial set : MANU ( 1/50 [1/60] )
( E type [U type] )
䡵 SHUTTER [Electronic shutter]
––MOD E S E L E C T ––
ID OFF
AGC GA I N 1 8 d B
SUPER AGC OFF
>SHUTTER MANU( )
BLC OFF
Av : Pk 8 : 2
W. BAL AUTO
HL I OFF
END
In such a case, the flickering and white balance variation can be
improved by setting the shutter speed to 1/100 [1/120] in an area
where the local power supply frequency is 50 [60] Hz or to 1/60 [1/
50] in an area where it is 60 [50] Hz. E type [U type]
Note:
When shutter speed is higher, goes to worse the smear which
is a phenomenon inherent to CCDs.
䡵 BLC [Back light compensation]
––MOD E S E L EC T ––
ID OFF
AGC GA I N 1 8 dB
SUPER AGC OFF
SHUTTER MANU ( )
>BLC OFF
Av : Pk 8: 2
W. BAL AUTO
HL I OFF
END
Variation values : OFF, AREA1, AREA2, AREA3, AREA4, EDIT1, EDIT2.
Factory setup : OFF.
1. Select AREA with buttons.
2. Press the SET button to show ”detecting“. Set the area as re-
quired.
3. When setting is done, press the SET button again and MODE
SELECT screen will resume.
Fixed area
AREA 1
Detecting
area
AREA 2
Detecting area
AREA 3
Detecting
area
AREA 4
Detecting
area
Set when there is a strong light source in
the background. The BLC provides four
fixed areas and 2 user-set areas.