Specifications

INSTALLATION AND SERVICE GUIDE
DeltaDome II Camera Dome
8000-2708-01, REV. B
32
6. Access tilt motor.
To do this, loosen captive retaining screw
holding tilt cable assembly in place and gently
remove this assembly.
7. Remove tilt motor (Figure 35).
Lift motor housing up as shown (1) to disengage
motor from tilt gear. Then pull motor bracket
towards outside of cable/tilt assembly (2) to
remove motor.
Figure 35. Removing the tilt motor
8. Reverse steps to reassemble.
CAUTION: When installing a new motor, be
careful to properly mesh motor and tilt gears!
Failure to do so can destroy both motor and tilt
gear. Verify tilt gear turns freely!
Tilt Motor
(Lift up, then out.)