Installation manual

46
MegaPower
TM
48+
Mode 3: Primary Matrix with 5 or 6 Secondary Matrices
Consult the figures on page 52 and 53 in order to connect video inputs and outputs to the system. Monitor outputs 8-15
from each secondary matrix must be connected to 8 video inputs on the primary matrix.
Eight full cross point switched monitor outputs are available by connecting monitors to video outputs 1-8 on the primary
matrix. Monitors can also be connected to monitor outputs 1-7 on each secondary matrix. These monitors can display
video inputs from that secondary unit only.
On all matrices, video output 16 is reserved for video-loss detection.
MONITORS 1-12
(PORT REFS. X1-X12)
CAMERAS 1-48
(PORT REFS. A1-A48)
CAMERAS 145-192
(PORT REFS. D1-D48)
MONITORS 13-15
(PORT REFS. A1-A3)
CAMERAS 49-96
(PORT REFS. B1-B48)
MONITORS 16-18
(PORT REFS. B1-B3)
CAMERAS 97-144
(PORT REFS. C1-C48)
PRIMARY MATRIX
CONNECT MONITOR OUTPUTS
4-15 ON SECONDARY MATRIX A
TO VIDEO INPUTS 1-12 ON
PRIMARY MATRIX
SECONDARY MATRIX A
CONNECT MONITOR OUTPUTS
4-15 ON SECONDARY MATRIX B
TO VIDEO INPUTS 13-24 ON
PRIMARY MATRIX
SECONDARY MATRIX C
MONITORS 19-21
(PORT REFS. C1-C3)
CONNECT MONITOR
OUTPUTS 4-15 ON
SECONDARY MATRIX C TO
VIDEO INPUTS 25-36 ON
PRIMARY MATRIX
MONITORS 22-24
(PORT REFS. D1-D3)
SECONDARY MATRIX D
CONNECT MONITOR OUTPUTS
4-15 ON SECONDARY MATRIX D
TO VIDEO INPUTS 37-48 ON
PRIMARY MATRIX
SECONDARY MATRIX B