Operator`s manual

TOUCH TRACKER Utilities 5-11

Adjusting Camera V-Phase

Use of this utility should be limited to authorized service personnel. To

adjust the V-phase of a selected camera, do the following:

1. Press

2. Using the Tracker Ball, scroll down to Adjust V-Phase.

3. Press the

Zoom

Focus

button to select the Adjust V-Phase

menu option.

4. Press

to observe the V-Phase through the

oscilloscope or Fluke scope.

5. Press

to exit.

IMPORTANT

Off-line domes or fixed cameras will generate a warning beep and disallow

use of the V-Phase utility. For additional information on adjusting the V-

Phase, see the service section of the AD Touch Tracker 16 manual.

Special Utilities

Although Show Sys Info and Ping Dome/TTR are considered utility

items on the menu, these utilities are reserved for use by authorized service

personnel. However, you may also perform these tasks in conjunction with

an authorized service provider over the phone. There are no procedures in

this documentation describing their use.