Operator`s manual

Defining Automatic System Functions 4-3
The T
OUCH
T
RACKER
is now in the menu/programming mode, and the
menu appears:
Calibration
Define Sequence
4. Use the Tracker Ball to scroll through the menu selections until Setup
View is displayed on the LCD.
Setup View
Record Pattern
5. Press the appropriate button, zoom or focus, to select Setup View.
The following prompt appears on the LCD:
Cam 7
Enter View#?
Note
If you press a number that has already been assigned to a Quick View for
this camera, the new Quick View will overwrite the existing Quick View.
There is no warning to indicate that the existing Quick View will be
replaced. Use caution.
6. Press the number on the keypad (1 - 96) that you want to assign to this
Quick View, then press
Zoom
or
Focus
.
The following message appears briefly on the LCD:
Cam 7
View Saved
If you press an invalid number (any number greater than 96), the T
OUCH
T
RACKER
beeps, and the system will not save the Quick View. If this
happens, simply press a valid number and the Quick View will be saved.
The T
OUCH
T
RACKER
automatically returns to the camera control mode.