Operator`s manual

3-2 Operator's Manual
Selecting Monitors
Monitors display the video from the cameras installed around your facility.
Each monitor has an identification number associated with it. To select a
monitor, use the number buttons to enter the monitor number, and then press
Mon
. Once a monitor has been called by the T
OUCH
T
RACKER
, you will see
its identification number in the MON field of the LCD. This monitor is
referred to as the called monitor.
The number of monitors available to display video input is determined by
your system configuration. Refer to the appropriate operating instructions to
determine the number of supported monitors.
Controlling Cameras
Each camera installed at your facility has a unique identification number. To
control a camera, you must first select the camera with your T
OUCH
T
RACKER
.
Then you can control the zoom, focus, iris, pan and tilt of the selected
camera.
The following illustration identifies the camera controls:
OFF
Mon Arm
ON
F
1
F
2
L
o
c
k
P
s
w
d
ON
Set
OFF
Auxi liary
Call
Prog
PG UP
PG DN
Close
Open
Clear
Iris
Mon
Ex
it
Last
Next
CAM
Site
B_PAS
Ack
E
N
TER
User
Cali b rate
Display
L
C
D
Cle
ar
Shot
Run
Hold
Salvo
Zoom button:
Press away
from you to zoom in; press
towards you to zoom out.
Tracker Ball:
Controls the
camera's pan and tilt.
Focus button:
Press away from
you to focus near; press towards
you to focus far.