Operator`s manual

2-2 AD168 System Operator’s Manual
d) Camera Section -
The CAMERA display window shows the number of the camera currently shown on the monitor
under keyboard control.
The LAST key calls the last previous camera displayed in a sequence.
The B-PAS key removes a camera from a sequence.
The ACK key acknowledges (clears) alarms from monitor screens, and starts system tours.
The NEXT key calls the next camera in a sequence.
The RUN key runs a camera sequence.
The HOLD key holds a sequenced camera on the monitor screen.
The SALVO key calls a pre-programmed salvo of camera scenes.
The CAMERA key selects a specified camera for view on the monitor under control.
e) Keypad Section -
The ENTER display window shows values entered on the numeric keypad.
The numeric keypad is used to enter numbers representing cameras, monitors, auxiliaries, etc.
The CLEAR key clears numeric data from the ENTER display window.
f) Dual Function Section note: the first member of each function pair is used with the keyswitch in the
OFF position. The second member of the pair is used with the keyswitch in the DISP position.
The OFF key turns off a specified auxiliary. ENTER stores data for a menu function.
ON turns on a specified auxiliary. EXIT exits a menu function.
CLOSE closes an iris to restrict light to a camera. The PAGE up arrow displays the last previous
page of a menu.
OPEN opens a camera iris to allow more light to the camera. The PAGE down arrow displays the
next page of a menu.
The NEAR key focuses the camera for near objects. The left arrow moves the cursor one character
to the left in a menu.
The FAR key focuses the camera for distant objects. The right arrow moves the cursor one character
to the right in a menu.
The WIDE key zooms out for a wide angle camera view. The up arrow moves the cursor up one line
in a menu.
The TELE key zooms in for a telephoto camera view. The down arrow moves the cursor one line in a
menu.
g) Preset Section -
The CALL key calls a specified preset scene (keyswitch in "off" position).
The SET key sets a particular scene as a preset (keyswitch in "prog" position).
h) Recessed Speaker - Provides an audio alarm tone.
i) Joystick - Enables movement of cameras with pan/tilt capabilities.