Technical data

CHAPTER 2: GETTING STARTED WITH SMS2 SMART CARD MANAGEMENT SYSTEM 2
23 Rev. B
2.2.2. Software Installation
1. Insert the SMS2 CD-ROM into your computer’s CD-ROM drive
and the Auto-Run program will begin. If Auto-Run starts proceed
to Step 2 (Page 25). If Auto-Run does not start proceed to Step a.
(below).
a. Click the Start button located on the Windows Task Bar
(Figure 2.1).
b. Click Settings (Figure 2.1).
c. Click Control Panel (Figure 2.1).
Figure 2.1 Starting Alternate SMS2 Installation
d. In the Control Panel folder, double click the add/remove
icon (Figure 2.2).
Note:
SMS2 is designed to run on a local hard drive. Network drives are not
supported at this time.
Note:
In order for Auto-Run to work properly, “Auto Insert Notification” must
be enabled in the Windows operating system. If it is not, consult your
Windows documentation to enable it, or follow these steps: