Instruction manual

American DJ® - www.americandj.com - Performance Scan 250™ Instruction Manual Page 18American DJ® - www.americandj.com - Performance Scan 250™ Instruction Manual Page 17
Performance Scan 250™ Fixture Cleaning
Performance Scan 250™ Trouble Shooting
Due to fog residue, smoke, and dust, cleaning the internal and exter-
nal optical lenses and mirror should be carried out periodically to
optimize light output. Cleaning frequency depends on the environ
-
ment in which the fixture operates (I.e. smoke, fog residue, dust,
dew). In heavy club use we recommend cleaning on a monthly basis.
Periodic cleaning will ensure longevity, and crisp output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Use a brush to wipe down the cooling vents and fan grill.
3. Clean the external optics and mirror with glass cleaner and a soft
cloth every 20 days.
4. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the unit
back in.
Listed below are a few common problems that you may encounter,
with solutions.
No light output from the unit;
1. Be sure the unit is plugged into a standard 120v wall outlet.
2. Be sure the fuse has not blown. The fuse is located at the front
of the unit, inside the power cord socket.
3. Remove the lamp socket assembly and be sure the lamp is
seated in its socket properly. Occasionally lamps become loose
during shipping be sure the lamp is push in to its socket all the
way.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
Performance Scan 250™ Selecting Voltage
Voltage Selection: Caution! Never attempt to change the voltage
while the fixture is plugged in. Always disconnect the main power
before attempting to change the voltage. You can see the photo
below for more help.
1. Be sure to
check the wall voltage, first before changing the volt-
age on the unit.
2. Unscrew and remove the four phillips screws located on each
side of the digital display.
3. After removing the screws, remove the digital display cover.
4. Select the voltage that matches the wall voltage. The selection
switch i
s located on the right side of the digital display.
5. Reassemble in reverse order.