Instruction manual
American DJ® - www.americandj.com - Accu Scan 250™ Instruction Manual Page 18American DJ® - www.americandj.com - Accu Scan 250™ Instruction Manual Page 17
Accu Scan 250™ System Menu
On-Board System Menu.
The Accu Scan 250™ comes with an easy
to navigate system menu. This next section will detail the functions of
each command in the system menu.
Accu Scan 250™ System Menu
ON/OFF - When “On” is chosen it will reverse the tilt.
MIC MENU -
M-01-M-70 - With this function you can make the internal mic
more or less sensitive to sound.
DISPLAY MENU -
VALU (DMX-512 Value) - Display the DMX-512 value of each
channel.
D ON (Display On) - Turns digital display on and off.
FLIP - “Flips” the digital display 180º.
SPEC MENU -
RDMX - On/Off With this function you are able to change the
DMX address via external controller. See pages 25-26.
SPOT - This provides a spot beam for better lamp optimization.
DFSE - This will reset the unit to the default settings.
VER (Version) - Software version 2.2
ADJU - Calibration functions
EDIT MENU -
STEP (Step) - Steps to be used in Edit Programming. See ediit
program. See page 29.
SCO1 - SC48 (Scene 01 - Scene 48) - These are the scene slots
that you write your programs into. See edit program, pages 29
- 32.
TIME (Time) - Time for each scene. See pages 29 - 32.
CEDT - Edit program using a external controller. See pages 29
- 32.
C-01 - C-30 (Channel 1 - Channel 30) - The channels of each
scene that can be edited. See pages 29 - 32.
ADDR MENU -
ADDR DMX Address Setting via control board -
1. Access the main menu.
2. Tap the UP button until “ADDR” is displayed, press ENTER.
3. “A001” will now be displayed. Press the UP or DOWN buttons
to nd your desired address. Press ENTER to conrm.
4. The display will show “PASS”, and then display, your selected
address again.
5. Press the MODE/ESC button to return to the main menu.
When the display is on “A001”, you can directly press the UP
or DN buttons to change the DMX start address.
TEST MENU -
TEST - This will test the functions of each channel.
1. Access the main menu.
2. Tap the UP button until “TEST” is displayed, press ENTER.
Enter Button -
To access the main menu locate the ENTER button
(15) on the front of the unit. Press this button to activate the system
menu. Tap the UP button (5) or DOWN button (14) until you reach func-
tion you wish to change. When you reach the function you wish to
change tap the ENTER button. When a function is selected the menu
will begin to ash, use the UP button to change the function. Once your
changes are made tap the ENTER button again to lock the change in
the system, if the ENTER button is not selected within eight seconds
the system will automatically return to menu section. To exit without
making any changes tap the MODE/ESC button (4).