Instruction manual

American DJ® - www.americandj.com - Accu Scan 250™ Instruction Manual Page 31 American DJ® - www.americandj.com - Accu Scan 250™ Instruction Manual Page 32
Accu Scan 250™ Editing Program
Editing procedure 2: Using an external controller.
1. Access the main menu.
2. Tap the UP button until “EDIT” is displayed. Press ENTER.
3. The display will show “SC01”, this stands for the scene
number to be edited. For example: If “SC01” is displayed, you
will be editing scene 1.
4. Change the scene number by pressing the UP button.
5. Press ENTER, the display will show “C-01”, the “1” stands for
the channel number 1.
6. Press the UP button until “CEDT” is displayed, press ENTER.
7. The display will show “OFF”, press the UP button so that “ON”
is displayed, press ENTER.
8. The display shows “SC02”. You have successfully down-
loaded the rst scene.
9. Adjust the Step-time. needed by pressing the UP button.
10. Call up the second scene in your controller now.
11. Repeat steps 3-6 until all desired scenes are downloaded.
12. Press MODE/ESC to exit. The number of steps can be
dened under “Step” and the scenes can be called up under
“Run”.
editing, the display will change to the next scene automatically.
13. Repeat steps 3-12 to edit other scenes, you can edit and
save 48 scenes maximum.
14. Press MODE/ESC to exit, now you have edited and saved
scenes using the control board. The number of steps can be
dened under “Step” and the scenes can be called up under
“Run”. To run the scenes see page 29.
Accu Scan 250™ Editing Program