User Manual

©American DJ® - www.americandj.com - Mega Flash DMX™ Instruction Manual Page 9
Designer.™
1. To control your fixture in DMX mode, follow the set-up procedures
on pages 5-6 as well as the set-up procedures included with
your DMX controller.
2. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
3. Assign your desired address to the unit, and “flip” dipswitch #10
to the “on” postion.
4. The
Mega Flash DMX™ uses two DMX channels. Channel 1 con
trols the flash sp
eed and chanel 2 controls the dimmer. Use your
DMX controller to activate the various built-in patterns.
See the
bottom of this page for the DMX traits.
5. For help operating in DMX mode consult the manual included
with your DMX controller.
NOTE: If running in Master/Slave address configuration while using a
DMX controller, follow the DMX address chart on page 12.
Mega Flash DMX™ Operating Instructions
Channel Value Function
1 0 - 255 FLASH SPEED
2 0 - 255 FLASH DIMMING
Mega Flash DMX™ DMX Traits
©American DJ® - www.americandj.com - Mega Flash DMX™ Instruction Manual Page 10
Warning! Allow the lamp to discharge all current. Allow the
unit 24hrs. to discharge before changing the lamp. Stored
current can cause a very severe shock.
Warning:
If after you have replaced the lamp or fuse and you contin-
ue to blow either one, STOP using the unit. Contact customer support
for further instructions, you may have to return the unit for servicing.
Continuing to use the unit may cause serious damage.
Fuse Replacement: Disconnect the unit’s main power supply.
Insert a standard flat head screw driver in to the fuse holder hous
-
ing (located on the rear of the unit). Turn the screwdriver in a coun
-
ter-clockwise direction to remove the fuse holder. Remove the old
fuse and discard it, replace the fuse with the same type. Insert the
fuse holder back into it’s housing and turn in a clockwise direction to
secure the holder in place.
Lamp Replacement: Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Lamp replacement has
been made simple by incorporating a remove tray that is retained by a
single thumb screws. Again, please remember to always replace with
the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew and remove the four phillips screws located on the front
cover of the unit.
Lamp Warning! Strobe lamps are filled with xenon
gas. This lamp is highly susceptible to damage if
improperly handled. Never touch the lamp with your
bare fingers as the oil from your hands will shorten
lamp life. Also, never move the fixture until the lamps
have had ample time to cool. Remember, lamps are
not covered under warranty conditions.
Mega Flash DMX™ Fuse and Lamp Replacement
Caution: Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
® technician.
Replace with anything other than the specified part can damage your
unit and will void your manufactures warranty.