User Manual

Delete a Chase

(1)

Select the Chase # button, 1-12, that you want to delete.

(2)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display stops flashing. A flashing Blackout indicator, in

the LED-display,is indicative that you are out of program mode.

(5)

Simultaneously, press the Auto/Del button then press the same Chase # button

that you selected in step 2. All LED's should flash three times to confirm that the

chase was deleted.

(3)

Repeat steps 2 & 3 to delete additional scenes.

(4)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display flashes. Once the indicator is flashing, record

mode is engaged and you may release the Program button.

Delete all chases

(1)

Flip the Operators power switch OFF which is located at the rear of the unit.

(2)

Simultaneously, press and hold down the Auto/Del and Bank Down buttons and

flip the power switch ON.All LED's will flash three times to confirm that all chases

were deleted.

(1)

1. Manual trigger:

(2)

When powered ON, this console defaults to Manual/Blackout mode. All output will

be in a black-out state until the Blackout button is deselected. To determine

blackout status there is an indicator light in the display that flashes when engaged

and OFF when disengaged. Press the Blackout button so the indicator stops

lashing.

Press the Chase # button, 1-12, that you want to playback. The selected chase

LED should illuminate.

(3)

Repeat steps 2 & 3 to manually playback additional chases.

(4)

Press the BANK UP & DOWN buttons, as desired, to manual step through your

chase steps. You can also manually adjust the Fade Time fader if you wish to

incorporate a crossfade between step.

Chase Playback

DMX OPERATOR 384