User Manual

ManualsBrandsAmerican DJ ManualsLight and Dimmer MixerDMX Operator 384

Recording Chases

This product has 12 programmable chases.Each of which can store up to 240 scenes/

steps. Please see the below instructions for chase setting.

(1)

(2)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display flashes. Once the indicator is flashing, record

mode is engaged and you may release the Program button.

(3)

Press the Midi/REC button to record the chase step. All LED's will flash three times

to confirm that the chase step was recorded.

(4)

Using the BANK UP & DOWN buttons, select the scene bank, 1-30, that contains

the scene you want added to your chase. You can view the scene banks in the LED-

display by referring to the furthest two digits to the right.You can also set your scene

using the eight Channel faders, joystick or data wheels and Channel Bank

button on the fly if desired. The Channel Bank button should be used to switch

between channel banks 1-8, 9-16, 17~24 and 25~32.

(5)

(6)

Once you've recorded all of your steps, press and hold down the Program button

for approximately 2 seconds to exit. A flashing Blackout indicator, in the LED-display,

is indicative that you are out of program mode.

Select a Chase # button, 1-12, that you wish to record to. The relevant Chase LED

should illuminate.

Repeat steps 3 & 4 to record additional steps.

Recording a Bank of Scenes to a Chase

(1)

(2)

(3)

(4)

(5)

(6)

Press and hold down the Program button for approximately 2 seconds or until the

PROG indicator in the LED-display flashes. Once the indicator is flashing, record

mode is engaged and you may release the Program button.

Simultaneously press the Music/Bkc and Midi/Rec buttons to record the entire

scene bank. All LED's will flash three times to confirm that the scene bank was

recorded. Scenes will record in the exact same sequence as stored in the bank.

Using the BANK UP & DOWN buttons, select the scene bank, 1-30, that you want

added to your chase. You can view the scene banks in the LED-display by referring

to the furthest two digits to the right.

Once you've recorded all of your steps, press and hold down the Program button

for approximately 2 seconds to exit.A flashing Blackout indicator,in the LED-display,

is indicative that you are out of program mode.

Select a Chase # button, 1-12, that you wish to record to. The relevant Chase LED

should illuminate.

Repeat steps 3 & 4 to record additional scene banks.

DMX OPERATOR 384